Installation Guide 01
Standard Screw Mount
Plan the mount location, identify the wall construction, and use hardware rated for the organizer and expected load.
Tools and hardware required
- Pencil
- Level
- Tape measure
- Drill and appropriate drill bit
- Screwdriver or driver bit
- Stud finder, if applicable
- Included screws and wall anchors
Important: Mounting hardware requirements depend on wall construction. Confirm that the included anchors are appropriate for your wall material. When mounting into a different wall construction, use suitable hardware for that material and the expected load.
Installation video
Follow in order
Step-by-step installation
- Choose and check the mounting location.
Confirm there is enough clearance for the organizer and gear. Check for concealed plumbing or electrical lines before drilling.
- Position the mounts.
Hold the rack at the desired height and use a level to align it.
- Mark the drilling points.
Press firmly on the rack at both the upper and lower mounts. The marking pins will leave small indentations showing where to drill.
- Prepare anchors where studs are not available.
Drill the correct pilot holes and install wall anchors suited to your wall construction and load.
- Attach the mounts.
Drive the screws until secure. Do not overtighten or deform the mount.
- Install the organizer.
Fit the organizer onto the mounts as designed, confirm it is fully seated, and test stability before adding gear.
- Install the accessory mounts.
Slide each accessory mount onto the rack from the top or bottom. If needed, apply gentle, even pressure to slightly spread the round opening as it passes onto the rack.